Substation Load Control Switchgears

Generac Automatic Transfer Switches are designed for use with single phase generators that utilize an Evolution or Nexus Controller. Through the use of digital power technology (DPM), these switches have the capability to manage up to 4 individual HVAC (24 VAC controlled) loads with no additional ha

Generac Automatic Transfer Switches are designed for use with single phase generators that utilize Evolution or Nexus Controllers. The 100, 200 and 400 amp open transition switches are available in single phase in both service equipment rated and non-service equipment rated configurations. The 150 a

Generac Automatic Transfer Switches are designed for use with single phase generators that utilize Evolution or Nexus Controllers. The 100, 200 and 400 amp open transition switches are available in single phase in both service equipment rated and non-service equipment rated configurations. The 150 a

The auxiliary transfer switch contact kit allows a single large electrical load to be locked out from the generator operation. If a home is equipped with electrical heat or multiple central air conditioning units, this device allows the generator transfer switch to interrupt the control wire, breaki

The Generac pre-wired switch is designed to operate with 9 to 16 kW air-cooled generators. This transfer switch has an integrated load center for picking up the emergency circuits. it is especially useful where the main service is large and only a portion of the building load will be served by the g

This 100 amp automatic transfer switch is used for transferring electrical load from a utility (normal) power source to a generator (standby) power source. Transfer of electrical loads occurs automatically when the utility power source has failed or is substantially reduced and the generator source

This 150 amp automatic transfer switch is used for transferring electrical load from a utility (normal) power source to a generator (standby) power source. Transfer of electrical loads occurs automatically when the utility power source has failed or is substantially reduced and the generator source

This 200 amp automatic transfer switch is used for transferring electrical load from a utility (normal) power source to a generator (standby) power source. Transfer of electrical loads occurs automatically when the utility power source has failed or is substantially reduced and the generator source

Unit substation, Mini Power-Zone, bolt on, 22.5kVA, 3 phase, 480V primary, 208Y/120V secondary, 65kA, CC